ER80 QR Code Access Card Reader can work with all Door access control board with built in WG 26/34output.The user can open the door by RFID card or Mobile QR code.
Card Reader Technical Parameter
Size(L*W*H)
|
86*86*42mm
|
Material
|
Case:PC identify panel:tempered glass
|
Interface
|
Wiegand26、34 、RS485、RS232、USB、TCP/IP optional
|
Decoding support
|
QR、one dimensional code
|
Voltage
|
Support 4-15V input
|
Current
|
800mA
|
Reading directions
|
Camera centric slant 45°
|
Reading speed
|
<200ms
|
Reading range
|
0-20CM
|
Reading feature
|
auto-induction, beep hint
|
Light source
|
With LED light source itself,anti-highlight interference
|
Decode Mode
|
Image decoding
|
environment
|
Temperature:-20~70℃ Humidity:10%~90%
|
Operate system
|
Windows(xp 7 8 10)、Linux
|
Indicating status light
|
Red-Work、Green-Feedback、Light Green-Internet
|
Reading range
|
3-6CM
|
Reading card type
|
EM or Mifare card
|
Restore Factory Settings: Use sharp objects inserted into backside REST hole,release till reader automatically restarted.
Features:
1. DC 12V 1000MA
2. EM card or Mifare Card for choose
3. Identify printed or screen QR Code
4. Support 26/34 weigand output to third party Access Control system
5. RS232, RS485, USB virtual keyboard, USB virtual Serial port, HTTP output, MQTT output optional
Wire connection:
VCC:DC12; GND:DC12;D0:DATA0;D1:DATA1; LED:LED indicate; BEEP:Sound ;
TX/R+:RS232+/RS485+;
RX/R-:RS232-/RS485-;
SPK-、SPK+:not define;
RJ45:connect to network, PC software setting reader parameter;apply to HTTP mode
micro-USB:For USB virtual keyboard and USB virtual serial port mode communication.
Note:
1: do not connect the power to the SPK+ and SPK- ports;
2:Wiegand output, QR code shall comply with the principle of combination of 16 hexadecimal number 0~F, the QR code in accordance with this principle can heard a Beep, controller can receive the card data; QR code not in accordance with the principle can heard two beep, the controller can not receive the card data;
3: Wigand output, scanning QR code take number principle is high before, QR code automatically identified as 16 decimal;
4: WG34 output, QR code card number must be 4 bytes, insufficient in high fill 4 byte number with 0.